Introduction: Arduino - DC Motor Control and PWM Signal With L298N H-bridge

By Maker 101
About: Maker 101; Beginner and intermediate level Maker projects! You can find projects such as "How to" and "DIY" on programmable boards such as Arduino, ESP8266, ESP32 and Raspberry Pi on this channel. The projects…

In this tutorial we will learn how to use the L298N H-Bridge Motor Controller.

We will control the dual DC motor with using the PWM Signals via L298N.

Step 1: Required Hardware

Arduino Board - https://goo.gl/Rqc5w2

L298N H-Bridge - https://goo.gl/Ucvx6J

DC Motor Wheel - https://goo.gl/iDy7ep

F to F Jumper - https://goo.gl/iDy7ep

M to M Jumper - https://goo.gl/iDy7ep

Battery - https://goo.gl/iDy7ep

Battery Clip - https://goo.gl/iDy7ep

Some Promotion Links

Flash Deals -- https://goo.gl/CVqg7P

Mega Stock Clearance -- https://goo.gl/eCbuiP

Arduino Kits -- https://goo.gl/uwr19e

More Budget 3D Printers -- https://goo.gl/uwr19e

Anet A8 3D Printer Promotion -- https://goo.gl/uwr19e

Step 2: L298N H-Bridge

This allows you to control the speed and direction of two DC motors, or control one bipolar stepper motor with ease.

Step 3: Connections

You can control the speed of the DC motors if the enable jumpers are removed.

Step 4: Source Code

You can just copy and paste the code into empty page of the Arduino IDE.

Get the Code - https://goo.gl/8PphQF

Step 5: You Can Subscribe to My YouTube Channel

You can subscribe to the my YouTube channel for more tutorials and projects. Subscribe for support. Thank you.

Go to my YouTube Channel - https://goo.gl/f0RHmR