Introduction: Arduino Motor

This is a motor "controller" but not really because it dosent overpower the motor and it dosent explode your house.. When you plug it in it runs and dosent smoke it just runs normally so I hope you like it!

Supplies

Any Arduino(with headers),a mini fan blade, an ac/dc adapter, a mini motor and red and blue wires.

Step 1: How to Build It

You need to connect the red wire to the pinholder on the Arduino that says "5V", then connect the blue wire to the pinholder on it that says "GND", then connect both of the other wires to the pins sticking out of the motor (it doesn't really matter which pin you put each wire on, one is forwards and one is reverse), and lastly connect the ac/dc adapter to the Arduino and plug it into the wall. There you go!