Introduction: Bridge for Make It Bridge Student Design Challenge

By

I used Tinkercad for the designing process and this bridge is designed for pedestrians to walk on and have a good time.

Supplies

All I used to make my design was tinker CAD and I used it to show the steps to making this bridge.

Step 1:

the first step is to make a board with the measurements

width: 40ft

length: 100ft

height:10ft

then put ramps on each side of the board.


Step 2:

Then add support beams so the bridge can last and hold so much people at once and the measurements are

width: 10ft

length:10ft

height:70ft

After that I had to put a railing that look cool so that people are interested in passing through the bridge and the measurements are

width: 2ft

length:73ft

height:60ft

Step 3:

Then I added benches so people can hang out and walk around or spend time with each other.

Step 4: Conclusion

If I were to do this project again, I would try to put for details on this project to make it look more nice and I would like to learn how to improve on using tinker cad.