Introduction: Duct Tape BandAid Case
More by the author:
About: I enjoy nature, science, classic rock, food, and having a good time. I don't have much of an imagination, but I am resourceful. I usually don't go for perfection, but merely to get the job done. I hope to publ…
So this is about how to make a handy little duct tape case for bandaids. I like to be prepared as I am an outside kid so either me, or someone else often gets hurt and it's nice when I can help them out. This is a simple project that wouldn't have to take more than 20 minutes, if you don't mess up.
Materials:
Duct Tape-- Not very much, but it depends
Measuring device, ruler, tape measure
Hands, scissors, or a knife-- to rip or cut the tape
The end result depends entirely on how you do it, this should just give you an idea of what I carry around with me just about everywhere I go.
Just look through all of the pictures, the steps are on them. Thank you.
Materials:
Duct Tape-- Not very much, but it depends
Measuring device, ruler, tape measure
Hands, scissors, or a knife-- to rip or cut the tape
The end result depends entirely on how you do it, this should just give you an idea of what I carry around with me just about everywhere I go.
Just look through all of the pictures, the steps are on them. Thank you.