Introduction: HOW TO ASSEMBLE AN IMPRESSIVE WOODEN ROBOT ARM(PART2: ROBOT FOR Avoiding Obstacle ) -- BASED ON THE MICRO: BIT

By Visit My Website
About: LewanSoul specializes in product development and creation, especially in the field of bionic robots, we provide the majority of users with superior hardware and software products. We have manufactured robots&r…

Previously we introduced Armbit in line-tracking mode. Next, we introduce how to install Armbit in avoiding obstacle mode.

Step 1: Written in the Front

With the previous installation of Armbit in line-tracking mode, we will install the Armbit in avoiding obstacle mode based on the installation of line-tracking mode.

Step 2:

Needed parts:

  • Screw package
  • Screwdriver
  • Anti-blocking servo

This part of the installation is based on the line-tracking mode and then modified.

Because the installation process in the early stage is consistent with the installation process in the line-tracking mode. You need to follow the steps shown in the picture to install. First, the ultrasonic module must be removed and mounted on the upper base plate. Then install the anti-blocking servo. Finally combined again. Pay attention to the port and the corresponding sensor. This part tests the ability to operate 4 stars.

Step 3: Its Gameplay.

The above shows the gameplay in the avoiding obstacle mode.

Next, we will introduce the remaining one form of the installation process.

Hope Armbit can be a good partner in your study and life!

Have fun~