Introduction: How to Make the Kingcobra Paper Airplane
The Kingcobra is a fast, sleek, long range origami interceptor paper airplane with the unique capabilities of hopping and sitting.
TAA USAF Designation: F63-1
TAA USAF Designation: F63-1
Step 1: Materials
Required:
1 Piece of 8.5 by 11 inch paper
Tape
Optional
Pencil
1 Piece of 8.5 by 11 inch paper
Tape
Optional
Pencil
Step 2: Start Folding
Start with folding it length-wise ("hot dog"-style). Then fold the corners in. Now fold along thecenter again.
Step 3: Fold Again
Fold the tip to the center. Then pull apart.
Step 4: Fold the Nose
Fold one side back in as pictured. Then fold them together.
Step 5: Fold the Wings
Start folding the wings. Fold each side down equally.
Step 6: Start Finishing the Wings
Now give the wings a dart-like leading edge. Then repeat on the opposite side.
Step 7: Security Fold
Now fold as pictured so the paper secures itself together. Fold it around the bottom and then you can tape the flaps down, though this is not required but preferable.
Step 8: Winglets
Time to construct the vertical stabilizers. Fold each equally.
Step 9: Flight
Launch the Kingcobra like you would a normal dart. Enjoy!