Introduction: How to Make Own Digital to Analog Convertor R 2R Ladder

By -eprojects.blogspot.com
About: An electronic engineer

Things Required :-

1. Resistors of two different value one resistor should have 'R' resistance and the other should have'2R' resistance. I used 220 for 'R' resistance and 2 x 220 ohm resistance for '2R' resistance.

2. A bread board to place resistors.

3. Multimeter to Check the voltage.

Step 1: Circuit Diagram

1. V1,V2,V3,V4 are the points were we are going to give digital Input .

2. VA is the Analog reference voltage were we get analog output.

Step 2: Check Out the Video for Clear Explanation If Not Understood

Comment to get your doubts clarified