Introduction: How to Make a Hot Dog Pen
This is a pen I made using a hot dog for the No Lathe Pen Challenge from One Car Workshop: ( http://onecarworkshop.com/2017/01/20/win-a-lathe-the-no-lathe-pen-challenge/ )
It’s silly, but I thought you might enjoy it.
Tools:
- Steamer
- Stove
- Plate
- Fork
- Ball-point pen
Materials:
- Hot dogs
- Hot dog buns
- Water
- Onion
- Ketchup
- Relish
Step 1: Boil Water
Load the boiler pot with water and get it boiling. Disassemble the pen to remove the body.
Step 2: Cook Hot Dog and Bun
Put the hot dog in the boiling water. Add the steamer basket and put the bun in. Close the lid.
TIP: Cook more than one hot dog. This will make you hungry and pens don’t taste good.
Wait 3 minutes. While you’re waiting…
Step 3: Chop Onions
Observe the magic onion-chopping trick!
If you don’t know magic, use a knife.
Step 4: Serve
Remove the bun and split it with the fork. Put the hot dog in the bun. Add onions, ketchup & relish.
Insert the pen into the hot dog from one end. If you can’t get it started, pierce the end with a fork first.
Step 5: Write / Eat
You’re done!
If you made two hot dogs, eat the other one. Congratulations on a job well done.