Introduction: How to Use 28BYJ-48 Stepper Motor With 3 Push Buttons
Do you want to controll your stepper motor using push buttons? That can do Clockwise, Counter Clockwise and then Stop function? Then this video is for you!
Step 1: Watch the Video!
First of all watch the video all the way for you to understand my instrucable.
Step 2: Component Lists
This are the components that i used for this project.
-28BYJ-48 Stepper Motor x1
-ULN2003AN Stepper Motor Driver x1
- Push buttons x4
- LiquidCrystal I2C Display x1
- Male to Female connector
- Jumper Wires
- Breadboard x1
- Arduino Pro Micro
Note: I use Arduino Pro Micro on this project because i used Breadboard for this project. But you can also replicate this project by using Arduino Uno.
Step 3: Do the Wiring!
Connect everything according to this schematic.
Step 4: Programming
Okay after connecting everything according to the Schematic in Step 3. download this code and Upload it.
NOTE: If you want an Explaination about this code go watch the entire video in my youtube i explained it there and if you're kind enough go subscribe and hit the notification bell thank you!
Step 5: CONGRATS!!
Congrats you have successfully created my intrucables! Even so don't forget to like share and subscribe to my youtube channel and i will see you next time 😊