KNEX GRENADE (stick)

This is my second grenade i hope everyone likes it it has shells for extra area of effect.

Step 1: Building the Base

(pic 1) build this by sliding the red connectors clip into the white connectors clip look at the pic for help.
(pic 2) keep doing the same thing from pic 1 until you have filled all of the remaining clips look at the pic for help.
(pic 3)do pics one and 2 again so u have 2 of the bases.

Step 2: Building the Handle

(pic 1) take a red rod and slide it through the white connector on the bases hole and add a tan connector. then add another tan connector to the other side. look at the pic if u dont understand.
(pic 2)just slide the first connector down
(pic 3)then slide the other one down
(pic 4) build this
(pic 5) now conect the red rod thats connected to the abse into the middle of the red connector that u just made in pic 4 then add another red connector to the bottom.This is a confusing step i would suggets looking at the picture.

Step 3: Building the Actual Grenade and the Shells

(pic 1) preety much just do exactly what you did with step one and the reds but add the yellows to the reds. make sure theyre all facing around in the same way. look at the pic for help.
(pic 2)build 6 of theese.
(pic 3) add the 6 shells into the midlle of the grenade
(pic 4) add the other base to the top.

Step 4: Elastics and Finnishing

(pic 1) add the alastics where shown
NOW YOUR DONE DO NOT THROW IT TOO HARD OR IT WILL BREAK IN THE AIR JUST KIND OF TOSS IT AND IT WILL STILL SMASH AND HIT EVERYTHING WITHING 5 METERS! HAVE FUN! POST COMENTS!