Introduction: Key Hanger
Step 1: Materials
First you will need a board doesn't matter how big but my key at the very end was 19x8in
Second you will need a way to cut the board you can use scroll saw jigsaw or bandsaw you could even use a coping saw
Next you will need a way to sand the board you can sand it any way you want really power sanding is quickest though
You will also need some keys it is best if they all look he same
And some screws to hold in the keys plus a screw driver and a pair of players to bend the keys
Second you will need a way to cut the board you can use scroll saw jigsaw or bandsaw you could even use a coping saw
Next you will need a way to sand the board you can sand it any way you want really power sanding is quickest though
You will also need some keys it is best if they all look he same
And some screws to hold in the keys plus a screw driver and a pair of players to bend the keys
Step 2: Plan
On the board you can either draw an old fashioned key or a new type of key I chose the old kind though
Step 3: Cutting
Cut out your shape using any merged you want
Step 4: Sanding
Sand any way you want you could even stain it if you wanted I didn't but I might later
Step 5: Key Bending and Finishing
Using the players bend the keys into hooks BECAREFUL THE KEYS BREAK VERY EASILY I actually broke two keys when doing this step
Now screw in the keys and hang up somewhere
P.S. there are many ways to hang this up use screws
Staples with string attached to them or any other way you can think of
Now screw in the keys and hang up somewhere
P.S. there are many ways to hang this up use screws
Staples with string attached to them or any other way you can think of