Introduction: Arduino LED
This is a simple light composed of LED.You can use it as a night light too.
You can buy the materials you need in the following stores:
The code link:
https://create.arduino.cc/editor/Jaylin20031208/8c...
You can watch the video in the link:
Supplies
Arduino Leonardo x1
LED x1
100Ω 1/4W resistor x1
Wire x3
Computer x1
Step 1: Assembly
Connect the long end of the LED light to the D12 jack
Step 2:
Connect the short end of the LED to one side of the resistor
Step 3:
Connect the other side of the resistor to the negative side of the breadboard
Step 4:
Connect a wire from the negative side of the breadboard to the GND jack
Step 5:
Boarding code
Step 6:
Appreciate the LED flashing