Introduction: Lasercut Diamonds
More by the author:
About: Hi! I'm a slightly feral mountain hermit that likes to be helpful. I do community management at Instructables & Tinkercad. 🙌 Want to hear me chat about making? Search "CLAMP Podcast" on YouTube or your favorit…
Drew this design in Inkscape - I'm planning on eventually making a garland out of lots of these! I thought it could be really cute.
I'm thinking about improving on the design a bit, the lower right side is a little thin - especially on the smaller ones! I had some one of them break this morning on my way into the office. I'll have to make more.
I'd like to use this in design in lots of ways - I'm thinking etching into something or making a stencil out of it.
I've included a couple of the shots while I was in the shop making them - but they're kinda low quality because it was taken with the camera on my phone. :)
I've also included the files I used, if you'd like to make your own. I have to admit I think these are much prettier than real diamonds. :D
I'm thinking about improving on the design a bit, the lower right side is a little thin - especially on the smaller ones! I had some one of them break this morning on my way into the office. I'll have to make more.
I'd like to use this in design in lots of ways - I'm thinking etching into something or making a stencil out of it.
I've included a couple of the shots while I was in the shop making them - but they're kinda low quality because it was taken with the camera on my phone. :)
I've also included the files I used, if you'd like to make your own. I have to admit I think these are much prettier than real diamonds. :D
