Introduction: Microbit
In this lesson you are going to learn about the use of microbit
Supplies
Needed supplies were
Microbit,
Multi meter,
Oscilloscope,
Piezo,
PIR sensor.
Microbit,
Multi meter,
Oscilloscope,
Piezo,
PIR sensor.
Step 1: First Step
First you have to place a microbit connect multimeter, oscilloscope,piezo,pir sensor in appropriate place.
You can connect with any types of pin but you have to mention that in your code .
You can connect with any types of pin but you have to mention that in your code .
Step 2: Second Step
First you need to mention the pin which you are connected piezo ,next mention under what integer value of PIR sensor the microbit have show safe or danger
Step 3: Third Step
Third and final step for the completion is you have to rotate the servo so mention the pulse and degree to rotate in your code
Step 4: Conclusion
I hope everyone could understand if any doubt ask in comment box
Thank you!
Thank you!