Introduction: GAME VS. ARDUINO ROBOT
The whole idea of this is to make an arduino contraption that can beat the phone game stack.
Supplies
- An Arduino Uno
- A Pvc Pipe
- A SG90 Servo Motor
- A Wood Block
- A Stylus
- A smart phone
Step 1: Watch the Video
Watch the video.
Step 2: Connect the Pvc Pipe to the Servo Motor
Glue the servo motor to one end of a pvc pipe, mine is 2 3/4 inch fit yours accordingly.
Step 3: Connect the Pvc Pipe to the Wood Block
Glue one end of the pvc pipe on the edge of the wood block mine is about 1/2 a inch high.
Step 4: Connect the Stylus to the Servo
Attach the stylus to the servo, my sylus is 4 inches.
Step 5: Connect the Servo to the Arduino
Connect the wires to the arduino uno accordingly.
- The yellow wire of the servo goes to digital pin 7 on the arduino.
- The red wire goes to 5volt of the arduino.
- And finally, the brown wire goes to ground of arduino.
Step 6: Complete Last Preparations
Tape the phone and wood block on the table, download stack on the phone, tape the phone on the table next to the arduino contraption, and last connect the arduino to the computer.
Step 7: Get the Code Ready
Upload this sketch on your arduino IDE.
/* Sweep
by BARRAGAN This example code is in the public domain.
http://www.arduino.cc/en/Tutorial/Sweep */
#include
Servo myservo;
void setup() {
myservo.attach(7);
myservo.write(125);
delay(200);
myservo.write(90);
delay(800);
myservo.write(120); }
void loop() {
delay(100);
myservo.write(90);
delay(700);
myservo.write(125);
delay(100);
myservo.write(90);
delay(700);
myservo.write(125);
// Change all servo and delay values if needed
}
Step 8: Enjoy!
ENJOY YOUR VERY OWN ARDUINO GAME BEATER!