Push Button Controlled LED

You will need - push button 1 , 5 white LEDs,4 greenLED ,1 RED LED Breadboard,5 male to male Jumper wires and Aduino UNO.

Step 1: You Will Need

1. You will need - push button 1 , 5 white LEDs,4 greenLED ,1 RED LED Breadboard,5 male to male Jumper wires and Aduino UNO.

Step 2: Arduino Board Connected to Breadboard

1. one jumpear wire goes to GND and another one goes to 5v

2.connect the wire to any + and - in bread board

3.connect push button and LEDs as directed in the picture

Step 3: It Works !!!!

1. 4 jumper wires to be connected to breadboard as directed in the picture

did'nt see any arduno website to make this.I made it by myself.I made it by myself.I did not take the photo because the LEDs were too bright to take a photo.does it work???? Yes it works for me.