Introduction: Self Watering Pot Plant From Drink Cans
Want to grow some herbs? Or have a pot plant which doesn't need to be watered everyday? If so, check this out.
Supplies
Material & Equipment:
Beverage cans
Wicking material (stocking)
4 pak can clip HDPE plastic
Sticky tape
Piece of cord
Plants (herbs)
Snap off knife.
Scissors
Glue gun
Cutting surface
Beverage cans
Wicking material (stocking)
4 pak can clip HDPE plastic
Sticky tape
Piece of cord
Plants (herbs)
Snap off knife.
Scissors
Glue gun
Cutting surface
Step 1:
Purchase and consume your favourite beverage.
Step 2:
Cut a can in half with the knife. Take care, consider eye protection. Finish cutting with scissors.
Step 3:
Trim edges to be straight and true with scissors.
Step 4:
Wash the wicking material (optional).
Step 5:
Turn top half of can upsided down, place wicking material through opening and into bottom half. Carefully fit top can onto bottom half. It's a snug fit.
Step 6:
Cut a 2nd can, about 3 cm (inch & a bit) from top. Trim both sides with scissors to be straight.
Step 7:
Cut bottom off 2nd can, straighten edge. Cut resulting ring down the middle with scissors.
Step 8:
Flatten , by rubbing over an edge.
Step 9:
Make a filling tube, by rolling a tube and securing with sticky tape.
Step 10:
Insert filling tube into can's drinking hole and secure with glue from glue gun.
Step 11:
This can now be used as a planter for herbs and placed on a kitchen window still. But wait, there's more..
Step 12:
Insert the planter onto the top section of prevously cut 2nd can.
Step 13:
Clip planter into pak clip. With filling tube outwards. Add a plant into the can. e.g. parsly. Clip in more planters.
Step 14:
Spread planters outwards with another tube, placed at base of can clip. Secured with glue from hot glue gun.
Step 15:
Make another set of planters, stack on top. Secure with cord.
Step 16:
Add water through filling tubes, and enjoy low maintainance gardening.