Introduction: Spill Juice Lamp
Give your study table or bed side a nice look with this spill lamp..
Step 1: Material
You`ll need the followings to make this lamp
1. A bright led of any color, i used red for a change
2. A 9v battery
3. some water
4. Tape
5. News paper
6. Cardboard
7. A pencil
8. Some glue
9. A battery dock
10. Some plastic cups
11. A switch
LETS GET STARTED
1. A bright led of any color, i used red for a change
2. A 9v battery
3. some water
4. Tape
5. News paper
6. Cardboard
7. A pencil
8. Some glue
9. A battery dock
10. Some plastic cups
11. A switch
LETS GET STARTED
Step 2: Assembling
Extend the wire of the led
then tape the led with the pencil
tightly.
the glue the pencil with the cardboard......
then tape the led with the pencil
tightly.
the glue the pencil with the cardboard......
Step 3: TESTING
woww BRIGHT
Step 4: The Cup
Poke a hole in the cup
then tape the cup at the top of the stand and tape the led inside the cup.
then tape the cup at the top of the stand and tape the led inside the cup.
Step 5: The Powerrr
Add the battery to the board. And remember to cover it fully with insulation tape to prevent damages during the paper mache process.
Step 6: Mug Design
take a paper of about the size of your cup and make a design which you want on your coffee mug
and add a paper handle to it....then glue it on the cup.
and add a paper handle to it....then glue it on the cup.
Step 7: Paper Mache
take some feviglue and mix it with water with the same ratio and mix it. Then dip some newspaper into the mixture and then cover your lamp stand.
Step 8: Paintings and Finishing
Paint the paper mache part with the color you want.....
And the after that add a switch between the battery and the led.............
And the after that add a switch between the battery and the led.............
Step 9: Thankings
Thank you for seeing this instructable please vote it in the battery powered contest and tarun upadhyas lamps and lightning contest .......... please vote and be nice because this was only my second instructable