Treat Feeder Dog Toy

girlscouttroop 'profile picture'

by girlscouttroop

56630

Intro: Treat Feeder Dog Toy

This fun toy that is designed to stimulate a dog's mind and get a tasty treat.

STEP 1:

Measure and cut the PVC pipe into 10"-long pieces. You can use either the PVC saw or a wire saw to cut the pipe.

STEP 2:

Sand the two ends of pipe.

STEP 3:

Glue a cap onto each end of the pipe. First use primer, then cement, and put the cap onto the end.

STEP 4:

Drill random holes that are about 1/2 - 1” in diameter. (I put the pipe into a table clamp to hold it still.) Sand the holes until they are smooth.

STEP 5:

Use Goo Gone to clean off glue that slipped out of cap.

STEP 6:

Put treats in PVC pipe and watch your dog enjoy rolling it around to get a nice treat.