Introduction: TrumpWAP - Make the Web Great Again
Remember when there were images of trump everywhere you looked on the internet?
With trumpWAP, we can make the internet great again!
Here you will find full instructions to make a super classy and functional trumpWAP of your own, using parts you can find around the house!
You can read more about what trumpWAP is and what it does here...
Step 1: 3D Print the Case
I comes in 3 pieces. It is important to print the hairplate in orange. The other colors don't matter.
The Fusion 360 model is here if you want it...
Step 2: Make It Classy
This is the most important step. Spray paint the case shiny gold.
Step 3: Add Some LED Eyes to the Backplate
This step is optional, but recommended. I used normal red LEDs, but you can use whatever you have.
Step 4: Set Up the Raspberry Pi
You'll need a Raspberry Pi 3, and SD card, and a power supply. If you don't already have one, here is a nice kit that comes with everything...
You can also use an old Raspberry Pi 1 or 2 with a Wifi adapter, but it will be even slower and suck.
Step 5: Install the TrumpWAP Software
Buy an SD card like this one....
...and burn the trumpWAP software into it according to these instructions...
https://github.com/bigjosh/trumpwap#ready-to-run-i...
ba BA ba.
Step 6: Put the Case Together
You'll have to print out the above face file on a piece of paper and cut it out with scissors.
Step 7: Install the Pi Into the Case
It doesn't really fit, so you have to jam it in there.
Step 8: Attach an Antenna
Step 9: Enjoy a Better Internet!
Your finished trumpWAP should look like this.
Use it.