Introduction: Arduino Voice Recognition. (Basic)

By www.newtonlabs.weebly.com
About: Hey YOU! Yeah, I'm talking to you who is reading this. Send me ideas for instructables, like things that you are wondering how to make or build, or really anything electronically related, and I'll get back to …
Hey guys, Today we have a great project for you. Arduino Voice recognition! We use the Easy VR and an Arduino. This project will teach you how to use the easyVR for Voice recognition: Note: Voice recognition is different from speech recognition,  voice recognition recognizes only a single person's voice, while speech recognition can recognize everybody's voice.










Submitted by Newton Labs for the Instructables Sponsorship Program

Step 1: Part List

EasyVR-Arduino shield: here!
||
OR EasyVR: here!
--------------------------------------------------------------------------------------------------
Arduino: here!


Step 2: Wireing

EasyVR TX->Arduino Pin 13 EasyVR RX-> Arduino Pin 12. Arduino 5V-> EasyVR 5V. GND->GND|||||||||||||||| Or if you have a shield, just put it on your Arduino. (If you can't tell where my wires are running in my pictures, then refer to the Circuit diagram made on Fritzing)

Step 3: EasyVR Library

You can get the library here!
You can get the EasyVR Commander here
You can get the Arduino IDE Software here! (if you don't have it yet)

Step 4: Programming

Make sure to have the easyVR-arduino library installed. Upload one of the samples. Then open the easy VR program, and program some commands (microphone required) by recording your voice. (Read pictures)

Step 5: Congratulations! You Have a Basic Voice Recognition System Set Up

Thanks and enjoy! If you have any questions ask them in the comments field.