Pico Gun Shotgun Mode

fires good but i have some problems with the hammer





sugestions are welcome

Step 1: Time to Assemble the Parts

the parts
14 grey connectors
5 red connectors
10 orange connectors

1 grey rod
1 red rod
6 blue rods ( for the handle ,its not required )

2 rubber bands or one veeeery big one

i am using green rods for the shotgun effect,but you can do it with really all rods exept the bendable rods

Step 2: Making Primary Parts

1.first put the orange connectors and the blue rods together
2.make the hammer
3. sorry for the picture but its just the 5 red connectors with green rods on a blue rod simple

Step 3: Put It Together !

it should work with just watching if not send me a mail or a comment and i will try to help

Step 4: Adding Rubber Bands

to begin put the rubber bands together as shown with the parts then
strap it through the grey connector and over the orange connector

Step 5: Firing

draw the hammer backwards and make shure the rubber band draws the red connectors to the side , put 5 green rods in the hole shown on the picture now pul the red connectors back from wher they came and of the bullet(s) go